Multiquip DCA20SPXU4F Manual de usuario descargar pdf (Pagina 32)



GENERATOR START-UP PROCEDURE (MANUAL MODE)



1. Place the   circuit breakers

(Figure 25) in the OFF position prior to starting the

engine.

Figure 25. Main, Aux. and GFCI

Circuit Breakers (OFF)

2. Connect the load to the receptacles or the output

terminal lugs as shown in Figure 11. Tighten terminal

nuts securely to prevent load wires from slipping out.

3. Close all engine enclosure doors (Figure 26).

Figure 26. Engine Enclosure Doors



1. On the control box, place the diagnostic switch (Figure 28)

in the OFF (down) position.

Figure 27. Diagnostic Switch (High)



The engine’s exhaust contains harmful emissions.

 

Direct exhaust away from nearby personnel.



 manually start the engine with the 

or auxiliary circuit breakers in the  (closed) position.

INCORRECTCORRECT

OFF (DOWN

)

2. Place the engine speed switch (Figure 28) in the LOW

(down) position.

Figure 28. Engine Speed Switch (Low)

3. Place the Auto-Off/Reset Manual Switch in the

position to start the engine (Figure 29).

Figure 29. Auto-Off/Reset Manual;Switch

(Manual Position)

4. Depending on the temperature of the coolant (cold

weather conditions), the pre-heat lamp (Figure 30) will

light () and remain on until the pre-heating cycle has

been completed. After completion of the pre-heating

cycle, the light will go OFF and the engine will start up

automatically

Figure 30. Pre-Heat Lamp

5. Once the engine starts, let the engine run for 1-2

minutes (let engine idle longer in cold weather

conditions). Listen for any abnormal noises. If any

abnormalities exist, shut down the engine and correct

the problem.

6. Verify that the engine started status LED on the ECU

controller is on.

NOTICE

In cold weather conditions warm up the engine 5-7

minutes before placing into operation.

NOTICE

If the engine fails to start after 3 attempts, the over-

crank LED on the ECU controller will turn on and the

Auto-Off/Reset Switch must be place in the Off/Reset

position before the engine can be restarted.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 103 104

Comentarios a estos manuales

Sin comentarios

Multiquip DCA20SPXU4F Manual de usuario Pagina 32

Comentarios a estos manuales

Relacionado con productos y manuales para Generadores Multiquip DCA20SPXU4F