Multiquip MQ POWER WHISPERWATT SERIES 60HZ GENERATOR (STD.) Manual de usuario descargar pdf (Pagina 41)

DCA800SSK2 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #0 (09/03/09) — PAGE 41

MAINTENANCE

JACKET WATER HEATER AND INTERNAL BATTERY

CHARGER 120 VAC INPUT RECEPTACLES

(OPTIONAL)

This generator can be optionally equipped with two 120

VAC, 20 amp input receptacles located on the output

terminal panel.

The purpose of these receptacles is to provide power via

commercial power to the jacket water heater and internal

battery charger.

These receptacles will ONLY function when commercial

power has been supplied to them (Figure 65). To apply

commercial power to these receptacles, a power cord of

adequate size will be required (See Table 6).

When using the generator in hot climates there is no reason

to apply power to jacket water heater. However, if the

generator will be used in cold climates it is always a good

idea to apply power to the jacket water heater at all times.

To apply power to the jacket water heater simply apply

power to the jacket water heater receptacle via commercial

power using an power cord of adequate size.

Battery Charger and Jacket Water Figure 65.

Heater Power Connections

If the generator will be used daily, the battery should

normally not require charging. If the generator will be idle

(not used) for long periods of time, apply power to the

battery charger receptacle via commercial power using a

power cord of adequate size.

NOTICE

To ensure adequate starting capability, always have

power applied to the generator's internal battery

charger.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 113 114

Sin comentarios

Multiquip MQ POWER WHISPERWATT SERIES 60HZ GENERATOR (STD.) Manual de usuario Pagina 41